+34 941 30 60 70
|58-03||Aluminium tube 58||60 ml|
|58-07-01||Kit chain 58 white||25|
|58-07+colour||Kit chain 58 colour||50|
The spring must be installed in the kit unscrewing the cap and screwing the spring. To obtain a major force the spring can be charged at time of installation rotating in the opposite direction to the fall of the fabric with 5 or 6 turns. The spring is installed right or left having always the roller blind in a front view and the fall of the fabric behind the tube. If the fall of the fabric is in front of the tube we will install an opposite spring to its side.The compensation spring should give a maximun of 25 turns. We have to charge the compensation spring with 3 turns for every Kg. supported. Depending on the fabric we will obtain heights from 5 to 5,6 lm. with a tube of 58 m/m.
The compensation spring should give a maximun of 25 turns. We have to charge the compensation spring with 3 turns for every Kg. supported. Depending on the fabric we will obtain heights from 5 to 5,6 lm. with a tube of 58 m/m
|58-05||Spring for tube< /td>||50|
|58-MTC||Kit motor 45 Cherubini Colours 01, 03, 33, 42, 72||50|
|58-MTS||Kit motor 45 Somfy Colours 01, 03, 33, 42, 72||50|
|58-MAV||Kit crank 58 Colours 01, 03, 33, 42, 72||50|
|MAV-07||Crank 2,8/1 - 6,5 Kg||50|
|MAV-12||Square pin 6, pin 10||50|
|MAV-13||Swivel joint 10 / 9,9||50|
|MAV-18||Conyrol rod 1,40 - 2,00 and 3,00||50|
|MAV-10||Wall support for rod||50|
|MAV-11||Jointed handle 1,40||50|
The geared down drive system can be used in 43 tube or 58 tube, It will depends on the adapters that we use.
The ratio is, from 1,75 to 1.
If it was necessary, it can be installed with compensation spring. Available in 28 colours.
|43-58||Geared down drive||50|
|58S-03||Set of brackets for 58||50|
|58S-08||Adapters for tube of 58||50|
|43-13||End less chain||50|
+34 941 30 60 70 · firstname.lastname@example.org